个人简介

一、基本情况

2022年4月毕业于南京航空航天大学，获工学博士学位。2022年6月至今任教于苏州科技大学机械工程学院，从事教学与科研工作。2024年被遴选为硕士研究生导师。

二、主要研究领域及学术成就

主持国家自然科学基金项目1项。已发表SCI论文30余篇，其中一作/通讯论文8篇，担任J Manuf Process等期刊审稿人。

研究方向为精密特总加工，主要包括：

1.高效精密特种加工工艺及装备研制；

2.FRCMCs的特种能场-磨削复合加工研究。

三、代表性科研成果

1.Zhang M, Qiu MB, Liu ZD. Effect of interpulse voltage on recast layer machined by HSWEDM.Mater Manu. Process,2024, 39(1): 90-97.

2.Zhang M, Guo HF, Guo CC, et al. Compensation method of wire electrode wear for reciprocating micro wire electrical discharge machining.J Manuf Process, 2023, 86: 136-142.

3.Zhang M, Liu ZD, Pan HW, et al. Multi-channel discharge characteristics cutting by ultra-fine wire-EDM.Chinese J Aeronaut, 2022, 35(2): 308-319.

4.Zhang M, Liu ZD Pan HW, et al. Effect of no-load rate on recast layer cutting by ultra fine wire-EDM.Chinese J Aeronaut, 2021, 34(4): 124-131.

5.Zhang M, Deng C, Yao Y, et al. Influence of bubble distribution produced by no-load pulse on straightness error in WEDM trimming.Int J Adv Manuf Tech,2025,140(1-2):277-285.

6.Zhang M, Zhao QY, Yao Y, et al. Synergistic mechanism of bubble evolution and material removal during the rough trimming in wire EDM‑ECM regulated by interpulse voltage.Int J Adv Manuf Tech,2025,140(5-6):3159-3169.

7.Zhang M, Liu ZD, Pan HW, et al. Discharge state identification and servo control method of high-speed reciprocating microwire-EDM.Int J Adv Manuf Tech, 2021, 112(1-2), 193-202.

8.Zhang M, Liu ZD, Pan HW, et al. Experimental research on combined processing of diamond wire saw and molybdenum twisted wire.Int J Adv Manuf Tech, 2019, 101(9-12): 2751-2759.

四、代表性科研项目

[1]国家自然科学基金青年项目：No. 52405506，2025.01-2027.12。（主持）